A water quality monitoring program of the Hawaii Geothermal Project well A (HGP-A) was conducted for downhole depth samples and continuous discharge samples in 1976 to 1977. The well water was slightly saline (about 5-10 percent ocean water) and nearly depleted of magnesium, but contained high concentrations of silica and sulfide. The chemical composition of the well water did not vary much with depth even though the sampling reached the well bottom [approximately 1768 m (5800 feet) below sea level]. The well fluid temperature was higher than that of any Hawaii ground water; a maximum of 358°C (676°F) was recorded at the bottom of the well. The water was low in tritium but unexpectedly high in carbon-14 when compared with the surrounding ground water [sampled as close as ~1609 km (1 mile) away]. Mass balance calculations involving carbon and its isotopes are consistent with a model proposing that 13 percent of recharge is from sea water. During continuous flow tests, the total well yield was 83,400 lb of steam per hour, equivalent to ~150 gpm with 70 percent steam and the rest water. For most constituents measured, there was a one to three day buildup period before approach to a steady state concentration. Water quality data, coupled with other measurements, indicate that the well is either poorly developed or located in a formation of low transmissivity. The moderately high rainfall and high surficial permeability allow substantial rain water infiltration. Actual subsurface water circulation is open to interpretation because of our uncertainty about geologic formations. Geophysical evidence suggests that deep dikes or intrusive bodies may be located on the ocean side of the well; such barriers would retard the encroachment of sea water into the well. ; Funded by grants from the National Science Foundation (GI-38319) and the Energy Research Development Administration (EY-76-C-03-1093).