For the smelting ferrotungsten of raw materials (mineral) took us to calculate the charge for each experiment. To optimize the process of obtaining ferrotungsten of wolframite carried out the followingactivities: to reduce speed and combustion temperature. A change batch positive impact on the development of the combustion process. Experimental results have shown the effectiveness of the introduction of aluminium additives in excess of stoichiometry because the explosive burning regime turned into stationary. In this work the charge calculated on 300 g volframite concentrate so that as a result of the aluminotermic reaction in the alloy contained 70% of tungsten. Calculations of charge showed that in the case of the smelting of ferro-alloys and master alloys used in this work and have a high melting point (ferrotungsten, ferromolybdenum, etc.) – temperature process of melting alloy is indispensable for the success of melting. To reduce the speed of combustion and the temperature were conducted experiments on selection of ballast additives which allows you to bring the process to a smooth flow of the reaction. As ballast additives used aluminium oxide. It was found that an increase of more than 20 additives reducing the release of the alloy and metal extraction. Also included experiments on selection of warm additives. Use as a warm additive of ammonium nitrate is not desirable because of the rapid reaction and loss of metal slag. The output and the extraction of metal in the application of potassium and sodium nitrate are the same but in the case of kalievoj nitrate slag can be used as a prolonged potash fertilizer. From the X-ray spectrometer alloys were analyzed.