Abstract With the increased use of tubular steel products, especially for hydroforming applications, it is important to be able to predict the performance of tube from sheet tensile tests. In the present study, two aluminum killed draw quality (AKDQ) steels and one high strength low alloy (HSLA) steel were evaluated. Tensile properties and plastic strain ratios were measured on sheet material in the longitudinal and transverse directions. Axial tensile tests were performed on material extracted from production tubes. Material from quasi tubes, which are strip material bent to the same curvature as the tubes but not welded or sized, was also tested. Residual stresses in the production and quasi tube were determined by displacement methods. A hydraulic burst test was performed on the production tubes to simulate a hydroforming operation. Effective strains resulting from tubemaking are calculated for two discrete operations: bending and sizing. For the production tubes, a linear relationship was found between a load factor (strength times thickness) and effective sizing strain. The relationship between load factor and residual stress was also linear. Predictions of the maximum pressure and the strain at instability during a hydraulic burst test are shown to compare favorably with experimental values, based on flat sheet properties and tubemaking strains. The prediction of the yield strength in the tube based on flat sheet properties is shown to be fairly accurate when the effective sizing strain is small compared to the effective bending strain.