Use of white irons for lining press molds

descriptionPublicationkeyboard_double_arrow_right Article 01 Mar 1964 English Publisher:Springer Science and Business Media LLCJournal:Refractories, volume 5, pages 164-167 (issn: 0034-3102, eissn: 1573-9139,

Copyright policy )

Authors: V. S. Popov; N. N. Brykov; N. S. Dmitrichenko;

doi: 10.1007/bf01291112

Use of white irons for lining press molds

- Summary
- Metrics

Abstract

In production conditions during the pressing of chrome-magnesite brick KhM-1 it was shown that the wear resistance of white iron with HRC- 51 is 2.5 times higher than plates of 20Kh steel after cementation and hardening with HRC=60–62. Gray and mottled irons are poorly resistant to abrasion. White iron of “e” composition is recommended, for press plates (see table). Alloying iron with chromium, as in the case of composition “e” is easily ensured by using naturally alloyed iron mark LKhCh-6 in amounts of 25% of the batch.

Impact byBIP!

	selected citations These citations are derived from selected sources. This is an alternative to the "Influence" indicator, which also reflects the overall/total impact of an article in the research community at large, based on the underlying citation network (diachronically).	0
	popularity This indicator reflects the "current" impact/attention (the "hype") of an article in the research community at large, based on the underlying citation network.	Average
	influence This indicator reflects the overall/total impact of an article in the research community at large, based on the underlying citation network (diachronically).	Average
	impulse This indicator reflects the initial momentum of an article directly after its publication, based on the underlying citation network.	Average