Turbidity currents are the volumetrically most import process for sediment transport on our planet. A single submarine flow can transport ten times the annual sediment flux from all of the world's rivers, and they form the largest sediment accumulations on Earth (submarine fans). These flows break strategically important seafloor cable networks that carry > 95% of global data traffic, including the internet and financial markets, and threaten expensive seabed infrastructure used to recover oil and gas. Ancient flows form many deepwater subsurface oil and gas reservoirs in locations worldwide. It is sobering to note quite how few direct measurements we have from submarine flows in action, which is a stark contrast to other major sediment transport processes such as rivers. Sediment concentration is the most fundamental parameter for documenting what turbidity currents are, and it has never been measured for flows that reach submarine fans. How then do we know what type of flow to model in flume tanks, or which assumptions to use to formulate numerical or analytical models? There is a compelling need to monitor flows directly if we are to make step changes in understanding. The flows evolve significantly, such that source to sink data is needed, and we need to monitor flows in different settings because their character can vary significantly. This project will coordinate and pump-prime international efforts to monitor turbidity currents in action. Work will be focussed around key 'test sites' that capture the main types of flows and triggers. The objective is to build up complete source-to-sink information at key sites, rather than producing more incomplete datasets in disparate locations. Test sites are chosen where flows are known to be active - occurring on annual or shorter time scale, where previous work provides a basis for future projects, and where there is access to suitable infrastructure (e.g. vessels). The initial test sites include turbidity current systems fed by rivers, where the river enters marine or freshwater, and where plunging ('hyperpycnal') river floods are common or absent. They also include locations that produce powerful flows that reach the deep ocean and build submarine fans. The project is novel because there has been no comparable network established for monitoring turbidity currents Numerical and laboratory modelling will also be needed to understand the significance of the field observations, and our aim is also to engage modellers in the design and analysis of monitoring datasets. This work will also help to test the validity of various types of model. We will collect sediment cores and seismic data to study the longer term evolution of systems, and the more infrequent types of flow. Understanding how deposits are linked to flows is important for outcrop and subsurface oil and gas reservoir geologists. This proposal is timely because of recent efforts to develop novel technology for monitoring flows that hold great promise. This suite of new technology is needed because turbidity currents can be extremely powerful (up to 20 m/s) and destroy sensors placed on traditional moorings on the seafloor. This includes new sensors, new ways of placing those sensors above active flows or in near-bed layers, and new ways of recovering data via autonomous gliders. Key preliminary data are lacking in some test sites, such as detailed bathymetric base-maps or seismic datasets. Our final objective is to fill in key gaps in 'site-survey' data to allow larger-scale monitoring projects to be submitted in the future. This project will add considerable value to an existing NERC Grant to monitor flows in Monterey Canyon in 2014-2017, and a NERC Industry Fellowship hosted by submarine cable operators. Talling is PI for two NERC Standard Grants, a NERC Industry Fellowship and NERC Research Programme Consortium award. He is also part of a NERC Centre, and thus fulfils all four criteria for the scheme.

Our overall aim is to make fundamental step-changes in understanding of seafloor processes and hazards by developing and demonstrating novel sensor systems, which can form widespread and long-term listening networks. These low-cost and energy-efficient sensors comprise hydrophones (acoustic noise in water column) and geophones (ground shaking). Data will be returned via pop-up floats and satellite links, as has been pioneered by the highly successful Argo Project for water-column profile. This type of low-cost network could have unusually widespread applications for warning against threats to valuable seabed infrastructure, monitoring leaks from CCS facilities or gas pipelines, or for tsunami warning systems. Here we aim to answer fundamental questions about how submarine mass-flows (turbidity currents and landslides) are triggered, and then behave. These hazardous and often powerful (2-20 m/s) submarine events form the largest sediment accumulations, deepest canyons, and longest channel systems on our planet. Turbidity currents can runout for hundreds to thousands of kilometres, to break seabed cable networks that carry >95% of global data traffic, including the internet and financial markets, or strategic oil and gas pipelines. These flows play a globally important role in organic carbon and nutrient transfer to the deep ocean, and geochemical cycles; whilst their deposits host valuable oil and gas reserves worldwide. Submarine mass flows are notoriously difficult to measure in action, and there are very few measurements compared to their subaerial cousins. This means there are fundamental gaps in basic understanding about how submarine mass flows are triggered, their frequency and runout, and how they behave. Recent monitoring has made advances using power-hungry (active source) sensors, such as acoustic Doppler current profilers (ADCPs). But active-source sensors have major disadvantages, and cannot be deployed globally. They can only measure for short periods, are located on moorings anchored inside these powerful flows (which often carry the expensive mooring and sensors away), and they need multiple periods of expensive research vessels to be both deployed and recovered. We will therefore design, build and test passive sensors that can be deployed over widespread areas at far lower cost. These novel sensors will record mass-flow timing and triggers; and changes in front speed (from transit times), and flow power (via strength of acoustic or vibration signal). We will first determine how submarine mass flows are best recorded by hydrophones and geophones, and how that record varies with flow speed and type, or distance to sensor. Our preliminary work at three sites already shows that hydrophone and geophones do record mass-flows. Here we will determine the best way to capture that mass-flow signal, and to distinguish it from other processes. This work will form the basis for designing a new generation of low-cost (< £5k) smart sensors that return data without expensive surface vessels; via pop-up floats and satellite links. Advances in technology make this project timely, as they allow on-board data processing by smart hydrophones or geophones to reduce data volumes, which can be triggered to record for short periods at much higher frequency. We will field-test the new smart sensors, and thus demonstrate how they can answer major science questions. We seek to understand what triggers submarine flows, and how this initial trigger mechanism affects flow behaviour. In particular, how are submarine flows linked to hazardous river floods, storms or earthquakes, and hence how do they record those hazards? Do submarine flows in diverse settings show consistent modes of behaviour, and if not, what causes those differences? To do this, we will deploy these new sensors along the Congo Canyon (dilute river, passive margin, no cyclones) offshore Taiwan.

Turbidity currents are the volumetrically most import process for sediment transport on our planet. A single submarine flow can transport ten times the annual sediment flux from all of the world's rivers, and they form the largest sediment accumulations on Earth (submarine fans). These flows break strategically important seafloor cable networks that carry > 95% of global data traffic, including the internet and financial markets, and threaten expensive seabed infrastructure used to recover oil and gas. Ancient flows form many deepwater subsurface oil and gas reservoirs in locations worldwide. It is sobering to note quite how few direct measurements we have from submarine flows in action, which is a stark contrast to other major sediment transport processes such as rivers. Sediment concentration is the most fundamental parameter for documenting what turbidity currents are, and it has never been measured for flows that reach submarine fans. How then do we know what type of flow to model in flume tanks, or which assumptions to use to formulate numerical or analytical models? There is a compelling need to monitor flows directly if we are to make step changes in understanding. The flows evolve significantly, such that source to sink data is needed, and we need to monitor flows in different settings because their character can vary significantly. This project will coordinate and pump-prime international efforts to monitor turbidity currents in action. Work will be focussed around key 'test sites' that capture the main types of flows and triggers. The objective is to build up complete source-to-sink information at key sites, rather than producing more incomplete datasets in disparate locations. Test sites are chosen where flows are known to be active - occurring on annual or shorter time scale, where previous work provides a basis for future projects, and where there is access to suitable infrastructure (e.g. vessels). The initial test sites include turbidity current systems fed by rivers, where the river enters marine or freshwater, and where plunging ('hyperpycnal') river floods are common or absent. They also include locations that produce powerful flows that reach the deep ocean and build submarine fans. The project is novel because there has been no comparable network established for monitoring turbidity currents Numerical and laboratory modelling will also be needed to understand the significance of the field observations, and our aim is also to engage modellers in the design and analysis of monitoring datasets. This work will also help to test the validity of various types of model. We will collect sediment cores and seismic data to study the longer term evolution of systems, and the more infrequent types of flow. Understanding how deposits are linked to flows is important for outcrop and subsurface oil and gas reservoir geologists. This proposal is timely because of recent efforts to develop novel technology for monitoring flows that hold great promise. This suite of new technology is needed because turbidity currents can be extremely powerful (up to 20 m/s) and destroy sensors placed on traditional moorings on the seafloor. This includes new sensors, new ways of placing those sensors above active flows or in near-bed layers, and new ways of recovering data via autonomous gliders. Key preliminary data are lacking in some test sites, such as detailed bathymetric base-maps or seismic datasets. Our final objective is to fill in key gaps in 'site-survey' data to allow larger-scale monitoring projects to be submitted in the future. This project will add considerable value to an existing NERC Grant to monitor flows in Monterey Canyon in 2014-2017, and a NERC Industry Fellowship hosted by submarine cable operators. Talling is PI for two NERC Standard Grants, a NERC Industry Fellowship and NERC Research Programme Consortium award. He is also part of a NERC Centre, and thus fulfils all four criteria for the scheme.